Troubleshooting of nail caps for nail making machines

   The common faults of the nail making machine in the production process of the workshop are as follows:
  1. No nail cap: This is a common fault for novices. Most of it is the reason why the fixture cannot clamp the nail wire tightly. You only need to replace the fixture; there is another nail that may be reserved for punching the nail cap. The wire is too short, just adjust the length of the reserved nail wire.
  2. The nail cap is not round: This fault is usually also on the fixture. First, observe whether the countersink hole on the fixture is round. smooth. There is also a problem with the nail wire, either the nail wire reserved for punching the nail cap is too short, adjust the length of the reserved nail wire; or the nail wire is too hard to punch out the nail cap or the nail cap is unqualified , the nail wire needs to be annealed.
  3. The thickness of the nail cap: It is also necessary to check the fixture to see whether the height of the two sets of fixtures is the same, and whether the fixture can clamp the nail wire, and to observe whether the sink hole of the fixture has serious wear on one side In the end, it is necessary to observe whether the nail wire is too hard and the punched nail cap is unqualified.
  4. The nail cap is skewed: first check whether the center of the two nail knives is consistent with the center of the nail mold, whether the front and rear heights of the nail knife are neat, and whether the counterbore positions of the two nail molds are on the same plane, and finally check the mold Whether the shell is loose.
  The problem of nail caps is nothing more than these points. As long as you are familiar with the working principle of the nail making machine, it is very simple to solve.