What are the procedures and steps of nail production?

   A small nail also needs a lot of procedures and steps. When all the procedures and steps are ready, the nail machine can produce large quantities of nails. Any idea what steps are needed?
  The automatic nail making machine is mainly divided into four parts, the most important one is wire drawing.
  Wire drawing——When making nails after purchase, you must determine what kind of steel bars will be used for nailing in the future, such as new steel bars, waste steel bars, etc. Drawing waste steel bars is more troublesome, not as fast as new steel bars, but the cost and profit of waste steel bars are very high Objective. The finished wire is drawn at a relatively fast speed, saving part of the manpower. The speed of nailing is also very fast.
  Production - After the wire is drawn, it passes through the fully automatic wire feeding machine head, and then the drawn wire is then fed into the wire feeding machine head to produce adjusted semi-finished nails.
  Polishing - Put the finished semi-finished nails into the polishing machine for polishing. The polishing machine puts some chemical raw materials such as sawdust, paraffin, gasoline, etc., and after friction and impact, it throws out shiny nails.
  Packaging - the above three parts are important, and the packaging can be customized according to the needs of users
  1. Feed material:
Use the waste heads left over from the prefabrication yard with a diameter of less than 8mm and a length of more than 10cm, and scrap steel bars, cold drawn wires, waste welding rods, and round heads removed from old houses as raw materials.
  2. Principle:
1. First, the raw materials are drawn and derusted by the wire drawing machine at the same time, and drawn into the diameter of the nails you need; 2. Then enter the nail making machine to make round nails; 3. Put them into the polishing machine (add raw materials) and throw them into the nails you need. The brightness is poured out; 4. The metering package leaves the factory. (It can also be drawn into grids, chicken coops, greenhouses, clothes hangers, car baskets, etc.)
  3. Parameters:
The nail length of this mechanism can produce 50 ~ 180 mm (2 inches, 2.5 inches, 3 inches, 4 inches, 5 inches, 6 inches, etc.) to replace the module to produce round nails of different specifications, the working voltage is 380 volts, 3 people operate, occupying an area More than 20 square meters, elementary school culture can be learned in 1-2 days, and it can be put into production after being connected to the power supply.